top of page

Polaris Matryx Mounting Installation Guide

Tools

  • 7/16" wrench - Box wrench or socket

​​

  • Ratchet and extension (if using a socket)

​

  • **10mm socket if using Matryx T-slot**

SnowMountz Placement

  • Determine the proper placement of your SnowMountz holder.

  • There are 3 sets of holes to space each mount in or outboard as needed.

  • The mount can also be rotated 180° for additional mounting options.

IMG_0869_edited.jpg
IMG_0868_edited.jpg
IMG_0867_edited.jpg

Matryx T-slot Mounting Position

  • Remove Matryx T-slot cover.

​

  • Install M6 carriage bolts into T-slot hole.​​

IMG_0865.JPEG

Matryx Factory Hole Mounting Position

IMG_0870.JPEG

  • Use Universal 1/4" mounting hardware.​

​

  • Install from inside of tunnel extending outward.​​

Install SnowMountz

  • Place your SnowMountz carrier over the mounting bolts​

​​

  • Install washers

​

  • For Universal mounting bolts use 7/16" wrench and socket to tighten mounting hardware​

​

  • For Matryx T-slot use 10mm socket to tighten mounting hardware.

​

NOTE: Since TPU is flexible and can compress it is possible to overtighten. Washer should NOT be visually deforming the carrier base.

IMG_0872.JPEG

Go Ride!

  • Check the fit to make sure that your skis or snowboard are not interfering with seat or any other components that could cause wear.

  • Secure with the Titan Utility strap

  • Go Ride!

IMG_0875.JPEG
bottom of page