top of page

Universal Side Mount Installation Guide

For all makes and models - Drilling is Required

Tools

  • SnowMountz Universal Side Mount

​​​

  • Ratchet and 7/16 Socket

​

  • 7/16 Wrench

​

  • 1/4" Drill Bit

​

  • Drill

​

  • Sharpie Marker

IMG_0790.JPEG

SnowMountz Placement

  • Determine the proper placement of your SnowMountz holder.

  • Lightly install Universal Side Mount to skis or snowboard and hold in place. Ensure that the straps are clear of boot mounting hardware and any other accessories mounted on the tunnel.

  • Check all mounting holes to ensure clearance to other structural fasteners (rivets and bolts)

IMG_0783.JPEG
IMG_0789.JPEG
IMG_0788.JPEG

Mark holes in determined location and check that there is no interference with structural hardware

Because your SnowMountz are made from flexible TPU material mounting overtop of rivets is not a problem as the Universal Side Mount will flex around the structural hardware.

Ensure that there is proper clearance on both inside and outside of the tunnel before drilling holes.

IMG_0786.JPEG
IMG_0787.JPEG

Drilling Mounting Holes

  • Use a drill and 1/4" bit to drill mounting holes.

​

Critical - Ensure that there is adiquate clearance to all water lines, structural components, and suspension. SnowMountz is NOT responsible for any damages caused my drilling holes.​​

IMG_0793.JPEG

Mounting Hardware

  • Install (4) bolts and washers into each Universal Side Mount

​

  • Install lock nuts to the inside of the tunnel finger tight.

IMG_0797.JPEG
IMG_0794.JPEG

Tighten Hardware

  • Use a socket to turn the mounting bolt while holding the nut with a wrench.​​

​​

  • Do not overtighten! Bolts should be snug and apply a small squish to the Universal Side Mount.

IMG_0798.JPEG

Go Ride!

  • Check the fit to make sure that your skis or snowboard are not interfering with seat or any other components that could cause wear.

  • Secure with the Titan Utility strap

  • Go Ride!

IMG_0801.JPEG
bottom of page